summaryrefslogtreecommitdiff
path: root/AtvTransmitterLv2.mdwn
blob: ef78d3a7bc9ef953662e49c60aa9deb23f016ca7 (plain)
1
2
3
4
5
6
7
8
9
10
11
# <a name="ATV Transmitter for LV2"></a> ATV Transmitter for LV2

Transmitter type: COP15-1200VT transmitter from [PC Electronics](http://www.hamtv.com)

Information on the pre-emphasis circuit and a de-emphasis circuit are at &lt;http://www.hamtv.com/FMATV.html&gt; Attached is a report of simulation of the pre-emphasis circuit.

These TX's may not be available. Have a PIC programmed to change the frequency into the ham band in a socket.

The unit we received has a pull up resistor to Vcc on pin 2, in addition to pin 2 being grounded. I suspect this is to provide one with the option of setting either state on pin 2. Tom's application note says pin 2 selects between a group of common AM or FM frequencies. We want 1253.25 MHz, so we want pin 2 grounded according to Tom's AN.

What we did to the exciter: \* Replaced F connector with an SMA \* Put a euro screw connector where the input wires are. \* Solder jumpered where the shunt block was \* Something else?